CA60Plus control panel Installation manual 31
8. VOICE DIALER PROGRAMMING PARAMETERS
ADDRESS 81 ENTERING TELEPHONE NUMBER 1 FOR THE DIALER
Tel No 1 A telephone number is assigned for communicating via voice dialer No. 1. The indication
is hexadecimal. The telephone number must not exceed 16 characters, including the “pulse
dialer” (ON and 0 buttons), “tone dialer” (ON and 1 buttons), “pause” (ON and 2 buttons),
“wait DIAL tone” (ON and 3 buttons) and “delete telephone number” (ON and 5 buttons)
symbols.
Dialing has been assigned a default tone signal
DEFAULT : there are no configured numbers
ADDRESS 80 RECORDING AND LISTENING TO VOICE MESSAGES
One can record and listen to messages in the voice dialer at this address. To record a
message place the REC jumper, select the number of the message by pressing the MSG key,
press and hold the PLAY key and dictate the message into the microphone immediately
when the LED lights up. Release the key. Remove the REC jumper when all messages have
been recorded. To listen to the messages connect an 8-16 ohm speaker to the SP socket.
Use the MSG key to select the number of the message, and press the PLAY key to listen the
recording.
DEFAULT : test message №8
ADDRESS 85 GROUPS OF MESSAGES FOR VOICE DIALER
TRANSMISSION
Programme the groups of message to be transmitted by the voice dialer at this
address. The possible options are 0 and 1. 0 transmits alarm messages by zones, and 1
transmits messages by events (see Supplement E).
DEFAULT : 1
ADDRESS 82 ENTERING TELEPHONE NUMBER 2 FOR THE DIALER
Tel No 2 A telephone number is assigned for communicating via voice dialer No. 2. The indication
is hexadecimal. The telephone number must not exceed 16 characters, including the “pulse
dialer” (ON and 0 buttons), “tone dialer” (ON and 1 buttons), “pause” (ON and 2 buttons),
“wait DIAL tone” (ON and 3 buttons) and “delete telephone number” (ON and 5 buttons)
symbols.
Dialing has been assigned a default tone signal
DEFAULT : there are no configured numbers
ADDRESS 83 ENTERING TELEPHONE NUMBER 3 FOR THE DIALER
Tel No 3 A telephone number is assigned for communicating via voice dialer No. 3. The indication
is hexadecimal. The telephone number must not exceed 16 characters, including the “pulse
dialer” (ON and 0 buttons), “tone dialer” (ON and 1 buttons), “pause” (ON and 2 buttons),
“wait DIAL tone” (ON and 3 buttons) and “delete telephone number” (ON and 5 buttons)
symbols.
Dialing has been assigned a default tone signal
DEFAULT : there are no configured numbers
ADDRESS 84 ENTERING TELEPHONE NUMBER 4 FOR THE DIALER
Tel No 4 A telephone number is assigned for communicating via voice dialer No. 4. The indication
is hexadecimal. The telephone number must not exceed 16 characters, including the “pulse
dialer” (ON and 0 buttons), “tone dialer” (ON and 1 buttons), “pause” (ON and 2 buttons),
“wait DIAL tone” (ON and 3 buttons) and “delete telephone number” (ON and 5 buttons)
symbols.
Dialing has been assigned a default tone signal
DEFAULT : there are no configured numbers
To Next Page
Loading...
