Teletek electronics CA62 - Page 44

44 Installation and Programming Manual - СА62 Alarm Control Panel
ADDRESS 6021 - ENTERING PROTOCOL 2 NUMBER FOR THE COMMUNICATOR
PROTOCOL 2
Enter central station No. 1 protocol number from the attached table. Valid are the symbols from 1 to
2, where:
Button Protocol
Indication
LED LCD
1 ADEMCO CONTACT ID*
     
1 2 3 4 5 (6)
2 SIA*
     
1 2 3 4 (5) 6
* Note: See also the code tables in the APPENDIX C.
Default settings - SIA
ADDRESS 6022 - TYPES OF MESSAGE TRANSMITTED FROM THE DIGITAL COMMUNICATOR, FOR PROT. 2
Messages The programming is the same as for ADDRESS 6012.
Default settings - No messages are assigned
ADDRESS 6030 - RECORDING AND LISTENING OF VOICE MESSAGES
VD60 Voice
Dialer Pro-
gramming
You can record and listen to messages in the voice dialer at this address.
At APPENDIX Е is given a detailed algorithm for recording and listening to of the voice messages.
Note: Recording and listening of voice messages can be done only if a voice dialer VD60 is integrated
to the CA62 control panel (main PCB ).
ADDRESS 6031 - ENTERING TELEPHONE NUMBER 1 FOR THE DIALER
Telephone
number 1 for
the dialer
A telephone number is assigned for communicating via voice dialer No. 1. The indication is hexadeci-
mal. The telephone number must not exceed 16 characters
Some special functions can be entered by using the next button combinations:
1. Buttons ARM + 0 - Switches on "pulse dialer".
2. Buttons ARM + 1 - Switches on "tone dialer".
3. Buttons ARM + 2 - 2 seconds pause.
4. Buttons ARM + 3 - Switches on "Wait dial tone".
5. Buttons ARM + 4 - "Blind dialing"; Switches off "Wait dial tone".
6. Buttons ARM + 5 - Deletes the entered telephone number*.
Dialing has been assigned a default tone signal and "Wait dial tone" function is switched on.
The entered telephone number and the special functions can be saved with pressing the ENT button.
* Note: When there are no entered phone numbers at this address, use this key combination to disable
the option "listening to the telephone line".
Default settings - there are no congured numbers
ADDRESS 6032 - ENTERING TELEPHONE NUMBER 2 FOR THE DIALER
Telephone
number 2 for
the dialer
A telephone number is assigned for communicating via voice dialer No. 2.
The programming is the same as at the ADDRESS 6031.
Default settings - there are no congured numbers
ADDRESS 6033 - ENTERING TELEPHONE NUMBER 3 FOR THE DIALER
Telephone
number 3 for
the dialer
A telephone number is assigned for communicating via voice dialer No. 3.
The programming is the same as at the ADDRESS 6031.
Default settings - there are no congured numbers
ADDRESS 6034 - ENTERING TELEPHONE NUMBER 4 FOR THE DIALER
Telephone
number 4 for
the dialer
A telephone number is assigned for communicating via voice dialer No. 4.
The programming is the same as at the ADDRESS 6031.
Default settings - there are no congured numbers