46 Installation and Programming Manual - СА62 Alarm Control Panel
6.2 Remote programming
The parameters for up / download programming of the integrated digital communicator and the VD60 voice dialer are
set on ADDRESSES 69хх.
ADDRESS 6901 - PERSONAL COMPUTER IDENTIFICATION NUMBER FOR UP / DOWN LOADING
PC ID
The PC ID number for up / down loading is congured at this address.
Four digits can be introduced. Valid are symbols 0 to 9.
The entered number is saved with pressing the ENT button.
Default settings - 1234
ADDRESS 6902 - CONTROL PANEL IDENTIFICATION NUMBER
Panel ID
The control panel up/down loading ID number is entered at this address.
Four digits can be introduced. Valid are symbols 0 to 9.
The entered number is saved with pressing the ENT button.
Default settings - 1234
ADDRESS 6904 - NUMBER OF RINGS
Number of
rings
The symbols 0 to 9 are used.
RINGS Up/ down loading is disabled if 0 is entered.
ATTENTION: It is recommended this parameter does not exceed the value of 7!
Default settings - 4
ADDRESS 6905 - ANSWERING MACHINE FUNCTION
Answering
machine
This address enables the Answering Machine function for up / down loading. Every push of the digital
button alternatively changes enabled to disabled status.
Priority should be given to any automatic answering devices (like FAX or telephone answering ma-
chines), if such are connected to the telephone line.
The Answering Machine function should be enabled in such cases. During initial income of a series of
calls (rings), the CA62 temporizes the maximum number of calls, set at Address 6904. The automatic
answering machine must be adjusted to a fewer number of rings. If within four minutes there is another
series of incoming calls the CA62 shall answer the rst one.
The display indication is shown in the tables below.
NO The "Answering machine" function is disabled.
Indication
LED
LCD
1 2 3 4 5 6
YES The "Answering machine" function is enabled.
Indication
LED
LCD
(1) (2) (3) (4) (5) (6)
Default settings - NO
To Next Page
Loading...
