Televic Plixus AE-R - Plixus AE-R Power Supply

Maximum power consumption
71.98.2051 - 71.98.2050 Plixus Nameplate (double sided &
single sided)
4W
Maximum distance between units 100m (signal regenerated in every
unit)
Minimum required voltage per unit 36V
The general rule states that you should use a maximum 20 delegate units per branch / loop.
Plixus AE-R Power Supply
The Plixus AE-R does not have an internal power supply, however it does have two power connectors. By
default you get one power supply together with the engine. You can extend this power supply with another
as redundancy or when the system requires more power.
To check how many power supplies you require, consult the flowchart shown below.
Plixus NEXT needed?
More than 40 units?
More than 200 W?
Plixus AE-R (71.98.2902)
Plixus Power Supply (71.98.2930)
required for network extender
Plixus AE-R Power Supply (71.98.2931)
for power redundancy
Plixus AE-R (71.98.2902)
2 × Plixus AE-R Power Supply (71.98.2931)
to power units
2 × DIN Rail Power Supply 48 Vdc - 10 A
for power redundancy
Plixus AE-R (71.98.2902)
Plixus AE-R Power Supply (71.98.2931)
for power redundancy
No
Yes
Yes
Yes
No
No
Figure 1-31 How to decide to need an additional Plixus AE-R power supply
POWER SUPPL Y DESIG N 62