Operation
Page 3-6
CYCLEPOWER CYCLEPOWER MODEM Cycletime
[DeviceAddress]
Example:
CYCLEPOWER MODEM 4 1
CYCLEPOWER MODEM 4 2
CYCLEPOWER MODEM 4
Cycles power on a modem.
Cycletime = in seconds
DeviceAddress = Modem Instance
Note:
The DeviceAddress is only used to distinguish
between multiple modems. Therefore, you can set
this value to either 1 or 2 (mapping to AUX1 or
AUX2). You can also specify the instance/name.
If no instance/name is specified and there is only
one modem, the modem instance will default to 2.
If more than one modem is on the NET-PATH, the
user is presented with modem instances and
names as follows:
There is more than one modem configured.
Please specify the modem instance or name.
1 Main Modem
2 Secondary Modem
If you specify any device other than MODEM, an
error is returned.
When entering strings (e.g. Modem Name)
surrounding quotes are not required. However,
when a name contains spaces, the quotes are
required.
DATE Date [MM-DD-YYYY]
Examples:
DATE 12-05-2003
DATE
Sets and /or retrieves the date. If you do not
specify a date, the current date is returned. The
format depends on the local format specified in
the Personality Module.
DATETIME DATETIME [MM-DD-YYYY HH:MM:SS]
Examples:
DATETIME 12-05-2003 11:12:00
DATETIME
Sets and/or gets the date and time. You do not
specify a date and time, the current date and time
is returned. The format depends on the local
format specified in the Personality Module.
Table 3-1: NET-PATH Commands
To Next Page
Loading...