NET-PATH Installation and Operation Guide
Page 3-15
A user access group assigned to a user profile controls access to commands. Some
commands listed in the table above are only available to users who enter the master
access password or the Teltronics factory password.
XPARA XPARA [hostname]
Examples:
XPARA
XPARA “My Host”
Initiates an active transparency to a host. When a
user issues a command, an enumerated list of the
serial hosts accessible to the current user displays.
If only one serial host is accessible to the user, an
active bridge transparency session immediately
initiates for that host.
Once a session is established, the system sends
any characters received from the host to the
connected user and also passes them to the
application (or script) for processing. Characters,
sent from the port via a terminal action or script,
are sent to the host, but not to the connected user
(unless the host is echoing characters). Any
characters sent by the user are sent directly to the
host port.
A user can terminate a command line active
bridge transparency session using the same
escape characters that are used to terminate
standard transparency (CTRL-A). Terminating
the transparency session this way returns the user
to the remote agent command prompt.
* This command is only available to Teltronics personnel.
Table 3-1: NET-PATH Commands
To Next Page
Loading...
Need help?
General