Need help?Do you have a question about the Tempo Communications Sidekick Plus and is the answer not in the manual?
General| Brand | Tempo Communications |
|---|---|
| Model | Sidekick Plus |
| Category | Test Equipment |
| Language | English |
Describes the Sidekick Plus test set's capabilities and field applications.
Emphasizes the importance of safety information in the manual.
Explains the North American terminology for test leads (Tip, Ring, Ground).
Explains the hazard symbol and signal words used in the manual.
Details warnings about electrical dangers and proper usage.
Defines safety categories (I, II, III, IV) for electrical measurements.
Lists and describes the primary components of the test set kit.
Explains the functionality of the four keys below the LCD screen.
Guides on performing AC and DC voltage measurements.
Explains the TDR feature for cable fault detection.
Describes the RFL functionality for finding faults.
Explains how to run a comprehensive automated test sequence.
Explains how to calibrate test leads for accurate measurements.
Details the resistance vs. distance calculation feature.
Details the optional impulse noise feature.
Explains how to control a Far End Device for advanced tests.
Guides on updating the unit's firmware from a USB drive.
Covers device settings like language, units, and frequency.
Allows configuration of cable types for TDR/RFL tests.
Explains customization of autotest parameters and thresholds.
Provides instructions for cleaning the test set and its case.
Covers battery recharging and the auto-off feature.
Details the procedure for replacing the battery pack.
Lists specifications for AC voltage measurements.
Lists specifications for loop current measurements.
Lists specifications for circuit noise measurements.
Details operating and storage temperature/humidity limits.
Outlines the standard warranty terms and conditions.
Details various warranty types like factory, contracted, and extended.
Guides the user through selecting the display language on first use.
Guides the user through selecting distance units (Feet/Metres).
Explains how to perform an impulse noise test.
Details how to set measurement filters and termination modes.
Explains the procedure for using the Step TDR feature.
Provides examples of Step TDR traces and their meanings.
Describes how to measure wideband loss across different impedances.
Explains measuring wideband noise using various filters.
Guides on configuring modem profiles for ADSL/VDSL synchronization.
Explains the modem synchronization process for DSL lines.
Explains how to interpret DSL test parameters like Showtime.
To Next Page