32
it for the Web-based Utility login next time.
5.1.2 LAN Settings in Wireless AP Mode
¾ MAC Address: The device’s physical MAC address as
seen on your local network is unchangeable.
¾ IP Mode: There are two modes, Static IP and Dynamic IP.
If you select Static IP, you need to input the parameters
provided by your ISP. If you choose Dynamic IP, you
should adjust the connection properties to obtain an IP
address and DNS sever automatically in Internet protocol.
¾ IP Address: The device’s LAN IP addresses (not your
PC’s IP address). 192.168.0.1 is the default value.
If you change it, you need to use the new IP to login to the Web
interface.
¾ Subnet Mask: It’s shown the device’s subnet mask for
To Next Page
Loading...
Need help?
General
