150Mbps Portable 3G Wireless Router User Guide
Appendix Ⅳ Troubleshooting
In this part some questions and problems shown during the
Router’s usage and installation will be given suggesting
answers. If your problems are not in the list, please log on to
our website www.tenda.cn or send an E-mail to
support@tenda.cn, and we will reply to you at the earliest.
1. Enter the IP address but can not visit the
WEB management interface. What can I do?
Please make sure the cable is well connected and the
corresponding indicator light up.
Make sure the device is not in Wireless Router mode. In
this mode, you can visit the WEB interface only by Wireless
network.
In the wireless access point (AP) mode, you must specify
an IP for your computer (192.168.0.2 ~ 192.168.0.254) to
access the device. Please click
“Start" - " Run "to enter “ping 192.168.0.1”to diagnose
whether the device is connected. If it can ping pass, then
check whether your browser enable a proxy server. If
enabled please disable it. If you can not ping pass, you can
hold down the "RESET" button for 7 seconds to restore the
factory settings, and “ping192.168.0.1” again.
2. Forget the login password and can not enter
the setting page. What can I do?
Press the “RESET” button for 7 seconds to restore the
To Next Page
Loading...
