71
Note
：
1. If you want to login the device’s Web-based interface via
port 8080, you need use the format of WAN IP address: port (for
example http
：
//220.135.211.56:8080) to implement remote login.
2. If your WAN IP address starts and ends with 0.0.0.0, it means
all hosts in WAN can implement remote Web management. If you
change the WAN IP address as 218.88.93.33-218.88.93.35, then
only the IP addresses as 218.88.93.33, 218.88.93.34 and
218.88.93.35 can access the Router.
For example:
If you want to configure the IP address 218.88.93.33 to access the
device’s web interface, please set it as above.
11.6 WAN Ping
The ping test is to check the status of your internet connection.
When disabling the test, the system will ignore the ping test from
WA N .
¾ Ignore the Ping from WAN:
Check to ignore the ping request and give no reply.
To Next Page
Loading...
Need help?
General
