Document version: V1.0
97
8.6.2
Configure Uplink Detection
Step 1
Choose Tools > Uplink Detection.
Step 2
Enable Uplink Detection.
Step 3
Enter the IP addresses of the host to be pinged in Host1 to Ping and Host2 to Ping, such
as the IP address of the switch or router directly connected to the Ethernet port of the AP.
If there is only one host IP address, enter this IP address in both Host1 to Ping and Host2
to Ping.
Step 4
Set Ping Interval to the interval at which the AP detects its uplink. The default value is 10
minutes.
Step 5
Click Save.
---End
To Next Page
Loading...
