Tenda W15-Pro - Example of Setting up a Wireless Network Encrypted with WPA or WPA2

Document version: V1.0
33
6.1.4 Example of Setting up a Wireless Network Encrypted with
WPA or WPA2
Networking Requirement
A highly secure wireless network is required and a RADIUS server is available. In this case, WPA or
WPA2 mode is recommended.
Assume that the IP address of the RADIUS server is 192.168.0.200, the Key is qtW7J5cA, and the
port number for authentication is 1812. See the following figure.
Configuration Procedure
I. Configure the AP
Assume that the second SSID of the AP, the WPA2 security mode, and AES encryption algorithm
are used.
Step 1
Choose Wireless > SSID.
Step 2
Select the second SSID from the SSID drop-down list box.
Step 3
Set Status to Enable.
Step 4
Change the value of SSID to hot_spot.
Step 5
Set Security Mode to WPA2.
Step 6
Set RADIUS Server, RADIUS Port, and RADIUS Key to 192.168.0.200, 1812, and qtW7J5cA
respectively.
Step 7
Set Encryption Algorithm to AES.
Internet
Router
PoE switch
SSID: hot_spot
RADIUS server
IP: 192.168.0.200
Key: qtW7J5cA
Port number: 1812
WAN
LAN
AP
IP: 192.168.0.254
LAN