Tenda W15-Pro - Page 30

Document version: V1.0
23
Parameter description
Parameter
Description
SSID
It specifies the SSID to be configured.
APs of this series support 8 SSIDs for the 2.4 GHz radio band and 8 SSIDs for the 5
GHz radio band. The first SSID displayed on the page under the radio band tab is
the primary SSID of the radio band.
Status
It specifies the status of the selected SSID.
Primary SSID is enabled by default while other SSIDs are disabled by default. You
can enable them as needed.
Broadcast SSID
It specifies the broadcast status of the SSID you selected.
When this parameter is set to Disable, the AP does not broadcast the SSID and
nearby wireless clients cannot detect the SSID. In this case, you need to enter the
SSID manually on your wireless client if you want to connect to the wireless
network corresponding to the SSID. This enhances the security of the wireless
network.
Isolate Client
It specifies whether to isolate clients connected to the same SSID.
When this parameter is set to Enable, the AP isolates the wireless clients
connected to the same wireless network corresponding to an SSID, so that the
wireless clients can access only the wired network connected to the AP. Applying
this function to hotspot setup at public places such as hotels and airports helps
increase network security.
Isolate SSID
It specifies whether to isolate the wireless clients connected to the AP with
different SSIDs.
When this parameter is set to Enable, devices connected to different SSIDs cannot
communicate with each other.
WMF
It specifies whether to enable the WMF function.
The WMF function of the AP converts multicast traffic into unicast traffic and
forwards the traffic to the multicast traffic destination in the wireless network.
This helps save wireless resources, ensure reliable transmission, and reduce
delays.
Max. Number of Clients
It specifies the maximum number of clients that can be concurrently connected to
the wireless network corresponding to an SSID.
If the number is reached, new devices cannot connect to the SSID unless some
devices cut off their connections.
SSID
Click it to modify the selected SSID (name of the wireless network).