Portable Wireless AP/Router
this mode, you can visit the WEB interface only by
Wireless network.
In the wireless access point (AP) mode, your computer
must specify an IP (192.168.2.2 ~ 192.168.2.254) to access
the device. Please click
“Start" - " Run "to enter “ping 192.168.2.1”to diagnose
whether the device is connected. If it can ping pass, then
check whether your browser enable a proxy server. If enabled
please disable it. If you can not ping pass, you can hold down
the "RESET" button for 7 seconds to restore the factory
settings, and “ping192.168.2.1” again.
2. Forget the login password and can not enter the setting
page. What can I do?
Press the “RESET” button for 7 seconds to restore the
Router to default settings.
3. The computer connected with the Router shows IP
address conflict. What can I do?
Check if there are other DHCP servers in the LAN. If there
have, disable them.
The default IP address of the Router is 192.168.2.1 and
please maker sure the address is not occupied by other
devices. If there are two computers with the same IP
To Next Page
Loading...
Need help?
General
