TM SERIES
2-8
472797 - 1/15 Terex South Dakota, Inc. TM Series
MAINTENANCE GUIDELINES
STORAGE PROCEDURE
When a unit will not be used for a period of time, it should be prepared for storage to reduce the deteriorating
effects of the environment. This includes the following:
• Wash and clean to remove accumulated road grime. It can discolor the paint if left on for long periods
of time.
• Clean and wax the fiberglass components. If storage is in the sun, cover the booms.
• Clean and coat the exposed cylinder rods with grease, preservative spray or heavy preservative oil.
• Clean and grease the exposed valve spools and linkage.
• Lubricate the entire Aerial Device following the lube chart.
• Check the oil for pH level and water content. Acidic oil or water in the oil may settle out during storage
and can rust the interior of the hydraulic system.
• Cover the platform to prevent water from accumulating. A platform full of water can weigh over 900
lbs. (408 kg) and exceed the capacity of the platform.
• Ensure the hydraulic tank filler-breather filter is intact to prevent dirt entering the tank when the
temperature changes.
• Grease all sliding surfaces where there is metal contact to prevent rust.
• Touch up any bare metal and where the paint is chipped or cracked.
• Spray the electric collector commutators with LPS 1 or CRC 5-56 to prevent corrosion of the surface.
• Service the truck as recommended by the manufacturer.
NOTE: The period of time between uses when the unit should be prepared for storage varies with
the location. If the climate is temperate and dry it may be 4 months. If it is in a humid area
next to the ocean with the salt air it may be only 2 weeks.
To Next Page
Loading...
Need help?
General
