TM SERIES
-XI
TM Series Terex South Dakota, Inc. 472797 - 1/15
SAFETY
1. Inspect, maintain, and repair this Aerial Device in accordance with the maintenance manual for this
device and the maintenance section of this manual.
2. Only authorized and qualified personnel with complete knowledge of this Aerial Device shall be allowed
to perform maintenance on this Aerial Device.
3. Never drill holes in the platform.
4. Replace all illegible decals.
5. Do not alter the insulated portion of this Aerial Device. Altering this Aerial Device in any way could
reduce its insulating value.
6. Do not search for hydraulic leaks with your hands or any other part of your body.
7. All hoses must meet or exceed the working pressure as stated in the maintenance manual.
8. Only use orange hoses marked NON-CONDUCTIVE for tool hoses, at the boom tip, and areas that
bridge the insulation gap.
9. Do not use replacement components that are not equal to the original components.
10. Before doing any work on the hydraulic system, secure the booms and outriggers. Release any
hydraulic pressure before attempting repairs or disassembly of hoses, valves, cylinders or any other
hydraulic components.
11. Fuel or oil spills may require notification of appropriate Federal, State, or Local officials.
12. Do not operate the Aerial Device after adjustments or repairs until all guards and covers have been
reinstalled, trapped air removed from the hydraulic system, safety devices reactivated, and maintenance
equipment removed.
13. The subframe, outriggers, and mounting to the vehicle must be inspected following the frequent and
periodic inspection intervals for fastener tightness, damaged components and weld inspections.
14. Inspect, maintain, and operate the vehicle and components following the manufacturer’s guidelines.
MAINTENANCE
To Next Page
Loading...
Need help?
General
