Tesla GATEWAY PRO - Content Sharing

38
TELSTRA GATEWAY PRO
™
USER GUIDE
5.1.1. Guest Wi-Fi Settings
Item Number
Wireless Settings
Items
Description
1
Wireless Settings
of Prole
This shows the settings and status of the selected prole in the Guest
Wi-Fi Settings screen
2
Enable Guest
Network:
If this check box is checked, then this guest network is enabled.
You and your visitors can connect to your network via the SSID of this
prole.
Enable SSID
Broadcast
If enabled, the Wireless Access Point will broadcast its name (SSID) to
all Wireless Stations. Stations which have no SSID (or a null value) can
then adopt the correct SSID for connections to this Access Point
Enable Wireless
Isolation:
When enabled, devices connected to your guest network can only
access the Internet. They won't be able to access any other devices or
log into your router.
Guest Wireless
Network Name
(SSID):
Enter a value of up to 32 alphanumeric characters. The same Name
(SSID) must be assigned to all wireless devices in your network.
The default SSID is SSIDN+1, N is the prole number, but Telstra
strongly recommends that you change your network’s Name (SSID)
to a different value. This value is also case-sensitive.
3
Security Options • None - no data encryption
• WEP - Wired Equivalent Privacy, use WEP 64- or 128-bit
data encryption
Note: Wi-Fi Protected Setup function is disabled when the security
setting is WEP authentication
• WPA2-PSK [AES] - Wi-Fi Protected Access version 2 with
Pre-Shared Key, use WPA2-PSK standard encryption with the
AES encryption type
• WPA-PSK [TKIP] + WPA2-PSK [AES] - Allow clients using either
WPA-PSK [TKIP] or WPA2-PSK [AES]
4
Password (Network
Key)
Enter a word or group of printable characters in the Passphrase
box. The Passphrase must be constituted of either 8 to 63 ASCII
characters or exactly 64 hex digits.
After making any changes click Apply at the top of the Wireless Settings screen and test your connection
with a Wi-Fi connected device.
5.2. Content Sharing
The Telstra Gateway Pro™ allows you to share the content stored on your USB connected storage device
with other users on your network. You can use the rear USB port or side USB port on the device.
Features
The Telstra Gateway Pro™ has two USB 3.0 ports.
The following le systems are supported:
• NTFS
• FAT32
• FAT16