Chapter 9 – Maintenance
TestEquity 1007C Temperature Chamber Page 9-15
Series F4 Temperature Controller Setup Parameters
! CAUTION: The “Series F4 User’s Manual” is a general manual and is written by the
manufacturer, Watlow, for a wide variety of applications and configurations.
Not all features or functions are applicable. Only the capabilities of a model
F4SH-CKA0-01, as described on page A.7 of the “Series F4 User’s Manual”
are applicable. “Cascade Control” as described on page 3.6 of the “Series F4
User’s Manual” is not applicable in this configuration. The “Retransmit”
function is available as an option.
! CAUTION: The Series F4 Temperature Controller has been properly configured by
TestEquity to match the chamber’s system requirements and to perform
optimally over a wide range of operating conditions. Improper modifications
to these setup values can result in erratic performance and unreliable
operation. Setup examples in the “Series F4 User’s Manual” are NOT
applicable to this chamber. Do not attempt to modify the setup values, unless
you thoroughly understand what you are doing. If there is any doubt, please
call TestEquity before proceeding.
! CAUTION: The alarm outputs of the Temperature Controller are NOT connected to the
chamber’s safety system. TestEquity does NOT recommend using the
Temperature Controller’s alarm function as the main protection device.
! CAUTION: NEVER select “Full Defaults” in the Factory/Test Menu. “Full Defaults” are
NOT the TestEquity configuration parameters for this chamber. If you select
“Full Defaults”, you must reconfigure all System and Operation Parameters as
documented in the TestEquity manual, NOT the “Series F4 User’s Manual”.
TestEquity has configured the Temperature Controller with the parameters as documented on the
following pages.
To Next Page
Loading...
