6 Using the product
34
Parameter Values
Temperature,
Relative humidity
and Absolute
pressure
The parameters must be correctly entered or
measured. This affects the measurement
with Pitot tube.
Thermal probe has an internal absolute
pressure sensor. No entry is required here.
Flow rate
correction factor
Must be 1.00 (has a proportional effect on
the flow rate).
Pitot factor Only has to be entered for measurement
with Pitot tube, see Pitot tube measurement,
page 38.
Channel geometry Profile and dimensions of the channel.
Select channel geometry with [ ]:
Electric power Manual input value, only used for logging.
4. In Explorer, under the created measuring point, create a new
grid measurement, see Explorer menu, page 27.
5. Make the following settings to suit the measuring point:
To Next Page
Loading...
