6 Using the product
30
> [ ] → New WBGT measurement: Carrying out a WBGT
measurement, see Turbulence measurement, page 37.
see PMV/PPD measurement, page 45
see WBGT measurement, page 44
6.6. Measurements & Measuring programs
General measurement information
• Depending on the measurement parameter to be measured,
certain probes must be plugged into the instrument.
• Some (thermal) probes require a warming-up phase until they
are ready to measure.
• Before every measurement, wait until the adjustment phase is
over. The adjustment phase ensures that the readings have
stabilized.
• For some measurement parameters, additional calculation
parameters must be set to ensure correct measurement results,
see Performing settings, page 20.
• In order to enable reliable data handling, the quantity of
measuring values to be saved for each measurement protocol
has to be restricted to 1 million individual values.
6.6.1. Retaining (“holding”) measurement values
Displayed measurement values can be held on the Favourites or
Probe tabs and printed out. The measurement values cannot be
saved in one measurement protocol.
> [ ] →Hold.
- The measurement value is retained. is displayed.
> Cancel Hold: [ ] →Hold.
Held measurement values can be printed see Printing
measurement values, page 52
The measuring values can be saved in one measurement protocol.
6.6.2. Quick back-up
With quick back-up, the current measuring values are saved to the
folder selected for the measurement.
If no measuring point has been selected, the measurement
protocols are saved under "Default Point".
> [ ] → Quick back-up.
- Measuring values are saved.
To Next Page
Loading...
