Texas Instruments DLP - User Interface: Internal Patterns Order

User Interface Overview www.ti.com
14
DLPU074A–August 2018–Revised October 2019
Submit Documentation Feedback
Copyright © 2018–2019, Texas Instruments Incorporated
DLP
®
Display and Light Control EVM GUI Tool
4.3.2.2 Internal Patterns Pattern Order Page
Figure 10. Internal Patterns, Pattern Order Page
On the Pattern Order page, users can configure the default order for pattern sets to display. It also allows
users to configure these pattern sets:
• number of patterns
• illumination selection
• exposure time
• pre-exposure dark time
• post-exposure dark time
After setting the pattern order table and the pattern orientation, the user can either load the pattern data
directly flash to run the patterns or save the pattern data on the computer to update the firmware later.
Review the timing diagram to ensure that the patterns and trigger signals are output as desired.
NOTE: Trigger controls available on this page are used to draw the timing diagram only, they do not
affect the functionality of the EVM.
Click Next on the bottom-right or any of the tab (Pattern Sets or Pattern Control) on the left to continue.