User Interface Overview
www.ti.com
4
DLPU074A–August 2018–Revised October 2019
Submit Documentation Feedback
Copyright © 2018–2019, Texas Instruments Incorporated
DLP
®
Display and Light Control EVM GUI Tool
Table 2. Page Description (continued)
Tab Page Section User Control Description
Debug
Event Viewer View the event occurred on the device
Command Log
View the command(s) issued to the device with the option to export
to a batch file
In addition, there is a separate GUI tool installed for the advanced user/mode (Section 4.6). This
advanced mode contains additional pages and commands that can be used with the EVM.
Use the questionmark icon (?) in the bottom-left corner of each section to provide access information on
that section and display the commands.
4.1 Information Tab
4.1.1 Information Page
Figure 3. Information Page
The information page shows status information the EVM after it is connected and powered on. Refer to the
guide on the left portion of the Information page to see how to set up the EVM.
The status of the EVM is displayed on the bottom-left corner of the Information page. The EVM Status
shows one of the following:
• Ready
• Connected, Incompatible EVM
• Connected, Powered off
• Not connected
To Next Page
Loading...
