Texas Instruments DLP - User Interface: Flash Image Update Completion

User Interface Overview www.ti.com
24
DLPU074A–August 2018–Revised October 2019
Submit Documentation Feedback
Copyright © 2018–2019, Texas Instruments Incorporated
DLP
®
Display and Light Control EVM GUI Tool
4.4.3.6 Update Flash Image Finish Page
Figure 20. Update Flash Image - Finish Page
The Finish Page page is not selectable. When the flash image build is completed, the finish page for
Update Flash Image display the information. To run the backup, click Yes on the bottom-left to go to the
Backup Firmware page. Click No on the bottom-right to go to the Update Firmware page to update the
EVM with the newly created flash image.