www.ti.com
User Interface Overview
15
DLPU074A–August 2018–Revised October 2019
Submit Documentation Feedback
Copyright © 2018–2019, Texas Instruments Incorporated
DLP
®
Display and Light Control EVM GUI Tool
4.3.2.3 Internal Patterns Pattern Control Page
Figure 11. Internal Patterns, Pattern Control Page
On the Pattern Control page, users can configure the trigger out, trigger in and pattern ready signals and
to control the display of patterns in internal patten mode. This page requires the EVM to be connected to
the GUI in order to work.
Configure the triggers and pattern ready signal as required and click Set. To view the current configuration
of these signals, click Get. After all the configurations are set, the user can select and control how to run
these patterns:
• run once
• run continuously
• pause
• step
• stop
• reset
The following commands are used on this page:
• Write trigger out configuration (0x92)
• Write trigger in configuration (0x90)
• Write pattern ready configuration (0x94)
• Write pattern order table entry (0x98)
• Write operating mode select (0x05)
• Write internal pattern control (0x9E)
• Read trigger out configuration (0x93)
• Read pattern configuration (0x97)
To Next Page
Loading...
