Texas Instruments DLP - User Interface: Advanced Tool - Connection; Connection Page

www.ti.com User Interface Overview
27
DLPU074A–August 2018–Revised October 2019
Submit Documentation Feedback
Copyright © 2018–2019, Texas Instruments Incorporated
DLP
®
Display and Light Control EVM GUI Tool
4.6.1 Connection Page
Figure 23. Connection Page
While the EVM is disconnected, the Connection page allows users to select these settings:
• I
2
C or SPI
• EVM type
• additional interface settings
It then connects or disconnects from the system. Always ensure that the EVM status set to Connected
before attempting to send any I
2
C commands in Advanced mode.