Texas Instruments DLP - User Interface: Display Settings and Keystone; Display Settings and Keystone Correction

User Interface Overview www.ti.com
8
DLPU074A–August 2018–Revised October 2019
Submit Documentation Feedback
Copyright © 2018–2019, Texas Instruments Incorporated
DLP
®
Display and Light Control EVM GUI Tool
• Read operating mode select (0x06)
• Read input image size (0x2F)
• Read display size (0x13)
• Read image crop (0x11)
• Read look select (0x23)
The following commands are used in the Color Temperature section:
• Read RGB LED current (0x55)
• Write RGB LED current (0x54)
• Write flash data type select (0xDE)
• Write flash data length (0xDF)
• Read flash start (0xE3)
• Write look select (0x22)
• Read operating mode select (0x06)
• Write splash screen execute (0x35)
• Read look select (0x23)
4.2.3 Display Settings Page
Figure 6. Display Settings Page
The Display Settings page has two sections; the Display Settings section and the Keystone Correction
section.
The Display Settings section lets user crops, scales, and rotates the input image. After all the desired
values are selected, clicking Set to send the new information to the EVM. Click Get lets user sees the
current display settings on the EVM.