Texas Instruments DLP - User Interface: Display Settings; Display Settings Page

User Interface Overview www.ti.com
6
DLPU074A–August 2018–Revised October 2019
Submit Documentation Feedback
Copyright © 2018–2019, Texas Instruments Incorporated
DLP
®
Display and Light Control EVM GUI Tool
4.2 Display Tab
4.2.1 Patterns and Images Page
Figure 4. Patterns and Images Page
The Patterns and Images page has two sections
• Display Patterns
• Splash Image
To set a display pattern, select the desired pattern, foreground, and background colors, and then click Set
in the Display Patterns section on the middle of the page. To confirm the display pattern, click Get .
To set a splash image, select the desired image, then click Set in the Splash Images section on the right.
Depending on what is stored in the flash memory, the actual image displayed may be different from what
is shown on the section.
Use these commands to set the display pattern:
• Write image freeze (0x1A)
• Write operating mode select (0x05)
• Write input image size (0x2E)
• Write image crop (0x10)
• Write test pattern select (0x0B)
• Read Test Pattern Select (0x0C)
The following commands are used to set the display image:
• Write Image Freeze (0x1A)
• Read Splash Screen Header (0x0F)