Updating the handheld operating system 97
Sending handheld
This message, along with a progress bar, is
displayed while the OS Upgrade is being
transferred.
Both handhelds
The sending and/or receiving handheld is not
properly connected. Reinsert the cable into each
handheld, then try the transmission again.
Receiving
handheld
This message is displayed when an OS Upgrade is
about to begin. If you do not select Yes within 30
seconds, the system automatically responds with
No.
Shown on: Message and Description
“Sending OS. Do not
unplug cable.“
“Transfer failed. Check cable
and try again.“
OK
“You are receiving an OS
Upgrade. Unsaved changes
will be lost. Would you like
to continue?“
Yes
No
To Next Page
Loading...
