Configuring the TI-Nspire™ CX handheld 65
Changing Graphs & Geometry settings in TI-Nspire™
documents
Complete the following steps to change Graphs & Geometry settings for
an open TI-Nspire™ document. You can apply the settings to the current
document only or choose to make the settings the default settings for
the open document and all future documents.
1. From an open document, press c522. The Graphs &
Geometry Settings
dialog box opens.
2. Click
¢ to open the drop-down menu for Display Digits, Graphing
Angle, or Geometry Angle settings, then press
¤ to view the values.
Press x or · to select a value.
3. In the lower half of the dialog, click a checkbox to enable or disable
an option.
4. Click
OK or press x or · to apply the new settings to the open
document and return to the
Home screen. When you click OK, the
settings are only applied to the open document.
To apply the new settings to the current document and all future
documents, click Make Default and press x or ·.
To Next Page
Loading...
