Texi Fox 25
22
Turn the thread hook into the needle hole
Screw driver
A
B
C
MECHANICAL ADJUSTMENT
AUTOMATIC THREADER POSITION
TO CHECK:
When the needle is on the highest position, check if the threading by automatic
threader is working.
If automatic threader cannot work properly, adjust as follows:
ADJUSTMENT PROCEDURE:
1. Remove face cover (See page2).
2. Loosen the setscrew (A).
3. Turn the hand wheel to raise the needle to its highest position. Pull down the
threader lever and turn the threader hook into the needle hole.
4. Push the position limit block (B) to highest place.
5. Tighten the setscrew (A).
NOTE: Setscrew (A) sho
uld be in one line with the screw(C).
6. Recheck the threader position.
7. Attach the face cover.
A