THERMACUT EX-TRAFIRE 45SD - 2� Cutting Parameters; 3� Two Variants of Cutting Torch

EX-TRAFIRE
®
45SD
Operator Manual, Revision T-54-38
2� Cutting parameters�
Setting the gas pressure�
Press the multifunction knob for 1 second, the cutting parametrs illuminate�
Press on multifunction knob briefly to set bar, MPa or psi�
3� Two variants of cutting torch�
hand torch machine torch
output voltage
visible after the arc transfer
autodetection
autodetection
of cutting torch length
Continue to press on multifunction knob briefly, the output voltage and detected length of the cutting
torch is displayed�