EX-TRAFIRE
®
45SD
Operator Manual, Revision T-512-78
Revision history:
1� Revision T-1/2020 - 02/2020 Official release
2� Revision T-2/2020 - 05/2020
a) New graphics of rear panel - rear panel without BUS connector
b) Page 3-28 - New paragraph - Gas pressure adjustment
c) Page 4-46 - new value of Voltage from: 7100 to: 115
(Mild Steel, Material Thickness =1�5 mm, Standard Quality Settings, Cut Speed=7100 mm/min)
d) Page 4-48 - new value of Cut Speed from: 510 to: 810
(Mild Steel, Material Thickness =10 mm, Best Quality Settings, Voltage=122 V)
e) Page 6-57 - New Part No� of item 5 - from: EX-5-419-201 - Hand (contact) Shield to: EX-2-419-201
f) Page 7-66 - Changes in error codes charter
g) Page 11-71 - New page of Warranty
3� Revision T-3/2020 - 07/2020
Page 1 - the latest version of manual link added
4� Revision T-4/2020 - 09/2020
a) Pages 3-32 - 34 - new pages -The circle cutting guide installation - for the FHT-EX
®
105RTXH/
105TTH/45TTH added
b) Page 7-63 - new items of additional ordering added
c) Pages 9-70, 71 - new items of accessories added - EX-0-802-000, EX-0-803-001, EX-0-803-004 and
EX-5-801-002
5� Revision T-5/2020 - 11/2020
a) Page 2-12 - note about PFC added
b) Page 3-33 - point No� 7 - note about lengths of bars added
To Next Page
Loading...
