Thermal Dynamics 42 CUTMASTER User Manual

CUTMASTER 42
Manual 0-5141 3-1 INSTALLATION
SECTION 3:
INSTALLATION
3.01 Unpacking
1. Use the packing lists to identify and account for each item.
A. Contents List
Description Quantity
CM42 Power source 1
10ft power input cable (installed) 1
120VAC Adapter Pigtail 15A 1
120VAC Adapter Pigtail 20A 1
Work cable and clamp (installed) 1
SL40 Torch (15ft(4.6m)) w/consumables 1
Carry case 1
40A Tip Drag 2
20A Tip Drag 2
40A Tip, Standoff 2
Electrode 2
Gloves 1
Cutting Glasses 1
2. Inspect each item for possible shipping damage. If damage is evident, contact your distributor and / or shipping
company before proceeding with the installation.
3. Record Power Supply and Torch model and serial numbers, purchase date and vendor name, in the information
block at the front of this manual.
3.02 Lifting Options
The Power Supply includes a handle for hand lifting only. Be sure unit is lifted and transported safely and securely.
WARNING
Do not touch live electrical parts.
Disconnect input power cord before moving unit.
FALLING EQUIPMENT can cause serious personal injury and can damage equipment.
HANDLE is not for mechanical lifting.
• Onlypersonsofadequatephysicalstrengthshouldlifttheunit.
• Liftunitbythehandle,usingtwohands.Donotusestrapsforlifting.
• Useoptionalcartorsimilardeviceofadequatecapacitytomoveunit.
• Placeunitonaproperskidandsecureinplacebeforetransportingwithaforkliftorothervehicle.

Thermal Dynamics 42 CUTMASTER Specifications

General

Brand	Thermal Dynamics
Model	42 CUTMASTER
Category	Welding System
Language	English