Thermal Dynamics CUTMASTER 60i Operating Manual

CUTMASTER 60i
Manual 0-5436 SERVICE
5-9
3. Remove the filter element and clean or replace..
NOTE!
If replacing or cleaning just the filter ele-
ment refer to the following illustration for
disassembly.
Art # A-07990
Filter Element
4. Install the new or cleaned assembly by reversing these procedures.
5. Turn ON the air supply and check for leaks before reinstalling the cover.

Thermal Dynamics CUTMASTER 60i Specifications

General

Brand	Thermal Dynamics
Model	CUTMASTER 60i
Category	Welding System
Language	English