Thermo Scientific APEX 100 User Manual

Page 332 Thermo Scientific APEX User’s Guide
4) If you are finished, go to the “Saving Your TCP/IP Settings” section—this is
important! Or continue the set-up as described below.
Changing the Gateway Address
In order to change the gateway address, DHCP must be set to “off.”
1) Make sure the gateway function is highlighted.
2) Press the Go button, and an input screen appears.
3) Use the navigation buttons to enter the gateway address, then press the Go button
to close the input screen. The flashing asterisk indicates the gateway address has
been changed.
Default Gateway Address
4) Go to the “Saving Your TCP/IP Settings” section—this is important!
MAC Addresses
Please note that the MAC address cannot be changed using the APEX software, because
it is set directly by the hardware.

Thermo Scientific APEX 100 Specifications

General

Brand	Thermo Scientific
Model	APEX 100
Category	Metal Detector
Language	English