Recalling a test
1. With the Absorbance Ratio screen displayed,
press Stored Tests. A list of stored tests
appears.
2. Use the arrow keys to highlight the name of
the test you want to recall and press ENTER.
The parameters for the selected test appear on
the screen.
From this screen, you can:
• Set up test parameters
• Run the Cell Correction program
• Save a test
• View the list of stored tests
• Measure a blank
• Measure unknowns
Setting up test parameters
1. With the Absorbance Ratio screen displayed,
use the arrow keys to highlight the name of the
parameter you want to set.
2. When the parameters are set, you can press
Save Test to save the test or Run Test to
measure a blank or unknowns.
Measuring unknowns
Measuring unknowns automatically (using Auto 6
or Auto 3)
1. Place the blank and unknowns in the correct
cell positions.
2. Press ENTER to start the measurement. The
instrument automatically measures the blank
first, then measures the unknowns and
displays the sample measurements on the
screen.
Measuring unknowns manually (using Manual 6 or
Single Cell Platform)
1. With the Absorbance Ratio screen displayed,
press Run Test.
2. Place the blank and unknown in the correct cell
position. If your instrument is equipped with a
6-Position Cell Holder, you can place up to five
samples in the cell holder.
3. Press Measure Blank to measure the blank. If
your instrument is equipped with a 6-Position
Cell Holder, it automatically moves to the B
Using “General Tests” Software
3-15 BioMate 3 Operator’s Manual
To Next Page
Loading...
