Chapter 3 | Replacing parts
Removing the motor
1. Remove the four long bolts located on the top of the motor assembly using a 1/4 in.
Allen wrench (Figure 3.16).
Figure 3.16. Removing one of the four bolts from the
top of the motor assembly.
2. Remove the top two bolts on both sides of the motor assembly using a 5/32 in. Allen
wrench (Figure 3.17).
Figure 3.17. Removing the top two bolts from the
side of the motor assembly.
3. Remove the top plate of the motor assembly (Figure 3.18).
Figure 3.18. Removing the top plate.
Thermo Scientific 19DynaDrive S.U.B. Service Guide
To Next Page