ThermoFisher Scientific HyPerforma DynaDrive - Page 53

Chapter 3 | Replacing parts
3. Pull the condenser heater towards you o of the heater mount (Figure 3.86).
Figure 3.86. Removing the condenser
heater from the heater mount.
Figure 3.87. Replacing the condenser
heater from the heater mount.
4. Replace with the new condenser heater by sliding the heater onto the heater mount
(Figure 3.87).
5. Plug the condenser heater cables into the filter heater ports (labeled Heater 1 and 2)
(Figure 3.88).
Thermo Scientific 49DynaDrive S.U.B. Service Guide