THOMSON SpeedTouch - Page 30

Chapter 3
Routed Ethernet
E-DOC-CTC-20051017-0167 v1.0
22
The IP interface Proceed as follows to create, configure and attach/connect the IP interface:
1 Create a new IP interface with name RtEthoa_ip.
2 Configure the new IP interface with as destination the Ethernet interface
created above.
3 Connect the IP interface.
IP address assignment Proceed as follows to assign an IP address to the IP interface:
1 Should the Routed Ethernet interface IP settings be obtained dynamically via
DHCP?
 If yes, go to step 2.
 If no, go to step 3.
2 Configure the DHCP client interface.
Proceed with step 5.
3 Enter the static IP address (for example 192.6.11.67) and netmask (for example
255.255.255.0) for the local side of the Ethernet connection. These should be
provided by your ISP.
4 Optionally, make this interface your default gateway.
5 Execute saveall at the prompt to save this configuration.
=>ip ifadd intf=RtEthoa_ip
=>
=>ip ifconfig intf=RtEthoa_ip dest=RtEthoa_eth
=>
=>ip ifattach intf=RtEthoa_ip
=>
=>dhcp client ifadd intf=RtEthoa_ip
=>dhcp client ifattach intf=RtEthoa_ip
=>
=>ip ipadd addr=192.6.11.67/24 intf=RtEthoa_ip
=>
=>ip rtadd addr=0.0.0.0/0 intf=RtEthoa_ip
=>
=>saveall
=>
For a complete description of all CLI commands, see the
SpeedTouch™ CLI Reference Guide.