THOMSON SpeedTouch - Page 36

Chapter 4
Bridged PPPoE
E-DOC-CTC-20051017-0167 v1.0
28
Interface road map The figure below shows the interfaces which have to be configured for Bridged
PPPoE.
Interfaces connected with red arrows are by default created and connected.
Interfaces connected with blue arrows need to be created and connected.
The colours used correspond with the colours used in the “ Protocol stack”.
PPP
PPPoA
IPoA
iARP
PPPoEIPoE /
IPoEoA
ARP
PPPoE RELAY
Multilink
PPP
EthoA
IP Interface(s)
IP Forwarding
Physical Ports
(Eth, USB, WLAN, BT...)
ATM VP/VC
(Over DSL / ATM-F)
ISDN
LoopBack
Ethernet Interface(s)
Bridge
VLAN
ATM Bundle
ATM Interface(s)