Chapter 4
Bridged PPPoE
E-DOC-CTC-20051017-0167 v1.0
29
Configuration procedure Proceed as follows to configure Bridged PPPoE:
1 Create, configure and attach/connect the ATM interface.
2 Create, configure and attach/connect the Bridge interface.
3 Check your configuration.
The ATM interface Proceed as follows to create an ATM phonebook and the ATM interface.
1 Add a new phonebook entry with name BrPPPoE_ph, VPI/VCI =8.35.
2 Add a new ATM interface with name BrPPPoE_atm.
3 Configure the new ATM interface with as destination the phonebook entry
created above.
By default, the encapsulation method will be LLC/SNAP.
4 Connect the ATM interface to the phonebook entry.
=>atm phonebook add name=BrPPPoE_ph addr=8.35
=>
If another phonebook entry with the same VPI/VCI already exists, you
will have to delete this entry first.
=>atm ifadd intf=BrPPPoE_atm
=>
=>atm ifconfig intf=BrPPPoE_atm dest=BrPPPoE_ph ulp=mac
=>
=>atm ifattach intf=BrPPPoE_atm
=>
To Next Page
Loading...
