Chapter 4
Bridged PPPoE
E-DOC-CTC-20051017-0167 v1.0
30
The Bridge interface Proceed as follows to create, configure and attach/connect the bridge interface:
1 Create a new bridge interface with name BrPPPoE_br.
2 Configure the new bridge interface with as destination the ATM interface
created above.
3 Connect the bridge interface.
4 Execute saveall at the prompt to save this configuration.
=>eth bridge ifadd intf=BrPPPoE_br
=>
=>eth bridge ifconfig intf=BrPPPoE_br dest=BrPPPoE_atm
=>
=>eth bridge ifattach intf=BrPPPoE_br
=>
=>saveall
=>
For a complete description of all CLI commands, see the
SpeedTouch™ CLI Reference Guide.
To Next Page
Loading...
