Chapter 4
Bridged PPPoE
E-DOC-CTC-20051017-0167 v1.0
31
Expected results To check whether you have configured your connection correctly, take a look at the
interface list. Normally you should be able to follow the path you created. This
interface list shows that the ATM interface with name BrPPPoE_atm is connected to
the bridge. In this way every frame coming from the ATM interface BrPPPoE_atm
will be put on the bridge.
The interface list does not include the ATM phone book entry. To check its state, go
to the ATM phone book list.
=>:interface list
Name Type State Use UL Interfaces
ethif1 physical connected 1 ethport1
ethif2 physical connected 1 ethport2
ethif3 physical connected 1 ethport3
ethif4 physical connected 1 ethport4
RELAY eth connected 0
bridge eth connected 1 lan1
OBC bridge connected 1 bridge
ethport1 bridge connected 1 bridge
BrPPPoE_atm atm connected 1 BrPPPoE_br
BrPPPoE_br bridge connected 1 bridge
ethport2 bridge connected 1 bridge
ethport3 bridge connected 1 bridge
ethport4 bridge connected 1 bridge
lan1 ip connected 0
The items in Italic are the interfaces created in this chapter.
=>atm phonebook list
Name Use Address
BrPPPoE_ph 1 8.35
To Next Page
Loading...
