MAIN MENU
P13
English
By Encrypt: Sort the channels from free to scrambled
7.2 Picture
Press MENU, then select Picture. In this menu you can adjust the video settings.
Press pq to select an option and tu to adjust the setting. Press EXIT to exit
the menu.
Aspect Ratio
The default and recommended format is Auto. You can also set the display format
to available settings like 4:3 Full Screen, 4:3 Pan&Scan, 4:3 Letter Box and 16:9
Wide Screen.
4:3 Letter Box: The full 16:9 picture will be displayed on your 4:3 TV set
with black bars above and below the picture.
4:3 Pan&Scan: The centre of the 16:9 picture will be displayed full-screen
on your 4:3 TV
4:3 Full Screen: Combination of Letter-box and Pan&Scan.
16:9 Wide Screen: Select when using a 16:9 TV set.
TIP: You can change the video output format directly from viewing mode
by pressing the YELLOW button on the remote control.
Resolution
If the video does not appear correctly, change the setting. These settings match the
most common settings for HDMI.
480i: for NTSC system TV.
480p: for NTSC system TV.
576i: for PAL system TV.
576p: for PAL system TV.
720p: for NTSC or PAL system TV.
1080i: for NTSC or PAL system TV.
1080p: for NTSC or PAL system TV.
TIP: You can change the video resolution directly from viewing mode by
pressing the GREEN button on the remote control.
TV format
Set the standard corresponding to your TV set. Available options are: PAL
and NTSC.
Video output
This setting is only relevant when the receiver is connected to the TV set via
Scart. Select RGB for the best picture quality or CVBS in case your TV doesn’t
support RGB.
Loop through (VCR to TV Scart)
This option is only relevant if you have a device (video-/DVD-recorder) connected
to the VCR scart connector of your receiver. Its signal will be looped through to
To Next Page
Loading...
