P20
MAIN MENU
WARNING: NEVER power off the receiver or pull the mains plug during the
software upgrade process. Doing so might cause irreparable
damage to your receiver and will void your warranty.
SW update by USB
Download the required update file for your receiver model from our website www.
thomsonstb.net (support page) or contact your local dealer.
Unzip the file on your computer, if necessary, and copy it to root folder of your USB
storage device.
Connect the USB storage device to the USB port of the receiver. Press MENU
and select Software Update By USB. Press OK to enter the software file list. Select
the file containing the software image and press OK to initiate the software update.
An attention banner will now be displayed. Press OK to start the update (or EXIT
to cancel it). Follow the instructions displayed on screen. The update process will
take some time. Once the update has been completed the receiver will display
“Software Upgrade Complete. Please Restart”. Unplug the receiver from the mains
and plug it in again. Your updated receiver will start with the last shown channel.
WARNING: NEVER power off the receiver or remove the USB device during the
software update process. Doing so might cause irreparable damage
to your receiver and will void your warranty.
Auto Standby
Auto standby is a new, power saving feature that helps you reduce power
consumption. It will switch off the receiver when no command is given for a defined
period of time. It is set per default to 180 minutes. With the tu buttons you can
choose between different time intervals or Off for disabling the feature. In the 0000
mode you can enter the desired auto standby time by using the 0~9 buttons.
NOTE: If there are timers running, the auto standby function will be disabled
for the booked time.
7.7 USB
Press MENU and select USB. The menu provides Multimedia features to playback
Music, Photo and Movie. The different supported file formats are listed below. In this
menu you can also see information about the total and free space of the connected
USB device, make video and photo configurations and format the USB device into
a format accepted by the receiver. The unit supports USB devices with FAT and
FAT32 format. Make sure your USB device is correctly formatted.
NOTE:
THOMSON cannot guarantee compatibility (operation and/or bus power) with all
USB mass storage devices and assumes no responsibility for any loss of data that
may occur when connected to this unit.
To Next Page
Loading...
