MAIN MENU
P19
English
7.6 System Settings
Press MENU and select System. In this menu you can adjust the system settings.
Press pq to select an option and press tu to adjust the setting. Press EXIT to
exit the menu.
Set Password
Set or change the password for locked programmes and menu access. Enter your
old password or the default password '0000'. You will then be asked to enter your
new password. To confirm, re-enter your new password. Press EXIT to exit the
menu after confirming.
Restore Factory Default
Reset your receiver to the default factory settings.
Select Restore Factory Default in the main menu and press OK or u to select.
Enter your password or the default password '0000' and press OK to confirm. This
option will delete all your channels and settings. The receiver will reboot and start
with the First Installation menu.
WARNING: A factory reset will permanently delete all your personal settings,
timers and stored channels. Please consider this before you perform
a factory reset.
Information
Shows model, software and hardware information.
Recall List
Enable or disable the Recall list function, which supports multi-recall channel
switching. If the status is set ON then, by pressing the RECALL button, a list of all
previously selected channels will be displayed for new selection. If the status is set
OFF then, by pressing RECALL button, the receiver will switch to the previously
selected channel.
Software update
Select Software Update in the main menu and press OK or u to select. There are
two software update options available:
SW update by OTA
The OTA (Over the Air) function allows you to search for software updates available
on satellite. Please ask your local THOMSON dealer or visit our website www.
thomsonstb.net for more information.
In the OTA menu all necessary THOMSON OTA settings (Satellite, Frequency,
Symbol rate and Polarization) are already set per default but could also be changed
manually. Press OK to initiate the update process. An attention banner will now
be displayed. Press OK to start the update (or EXIT to cancel it). Follow the
instructions displayed on screen. The software searching and update process
could take up to 20 minutes depending on the data volume in stream. After the
process has been completed (also if no update was found) the receiver will reboot
and start with the last shown channel.
To Next Page
Loading...
