THOMSON THS220 - 7.0 MAIN MENU; Programme Management

MAIN MENU
P17
English
7.3.7 Transponder Edit options
Transponders can only be edited when the transponder list is on screen. To do
this, select the satellite you wish to edit and press GOTO to open the TP list. The
options below are now available.
Add transponder: Press RED to add a new transponder. In the pop-up
banner, enter the transponder´s data with the navigation
and numeric buttons. Confirm the settings with OK or
cancel with EXIT. An existing TP cannot be stored again
under the same satellite.
Edit transponder: Press GREEN to edit the highlighted transponder. In the
pop-up banner, change the transponder´s data with the
navigation and numeric buttons. Confirm changes with OK
or cancel with EXIT.
Delete transponder: Press YELLOW to delete the highlighted transponder.
Press OK to confirm or EXIT to cancel.
7.3.8 DB Management
This menu allows you to save and reload the channel data base of your receiver
from/to a USB-device. This very convenient feature enables you to save your
personal settings like Channel-, Favourite-, Sat- and TP-lists on a USB storage
device and load them back to the receiver later. This feature is especially
helpful after unintentional changes or factory reset. In such cases just skip
the First Installation by pressing EXIT in the First Installation and select the DB
management menu.
Connect the USB storage device to you receiver and select one of the options:
7.3.9 Load from USB
Press OK for displaying the list with available DB files (if any stored before). The
DB files „xxxxx.DBM“ are shown with their built date (day and month). Select the
DB file you want to load and confirm it with OK. If DB was loaded successfully
(message appears on screen) the receiver switches automatically to the first stored
channel and shows its content in the background. Press EXIT until the OSD
menu disappears.
7.3.10 Backup to USB
Press OK to make a backup of the data base. A DBM-File „xxxxx.DBM“, with the
current date (day and month), will be created on the USB-device. If DB was stored
successfully, a message will be displayed on screen. Press EXIT until the OSD
menu disappears.
7.4 Time and Date Settings
Press MENU and select Time. In this menu you can adjust the time and
date settings.
Press pq to select an option and tu to adjust the setting. Press EXIT to exit
the menu.