MAIN MENU
P15
English
DiSEqC1.2: Move the motor to the right position for locking the signal
like explained below.
Move Continue: press tu for moving West/East. It will keep moving as
long as the button is hold pressed. Pressing once moves in
1°step.
Move Step (1): press tu for moving West/East in 0.3° step.
Store Position: to store the current motor position for the selected satellite.
Goto Reference: to go to the reference 0° position.
DiSEqC1.3: Select DiSEqC1.3 with the tu buttons. Press GREEN
to setup your location coordinates. A pop-up window will
appear, in which the following settings can be made:
Location: Use tu to select one of the pre-set locations. Choose a
location nearest to you. If you know the coordinates of your
place of residence, you can choose Manual and make the
following extra adjustments:
Longitude Direction: Choose East or West.
Longitude Angle: Use the NUMERIC buttons to enter the coordinate.
Lattitude Direction: Choose North or South.
Latitude Angle: Use the NUMERIC buttons to enter the coordinate.
Once all setting are made, press EXIT to save the data and leave the window.
Now press OK to enter the DiSEqC1.3 menu.
Move Auto will move the dish to the selected satellite automatically.
For Move Continue, Move Step (1) and Goto Reference please see
explanation above.
7.3.4 Channel Scan
Automatic Scan
Single Satellite Scan: Press BLUE for Scan. A window with scan settings will
be displayed.
Scan Mode: Use tu to select Default, Blind Scan or NetWork.
Default: All stored transponders in the memory will be scanned.
Blind Scan: Slow scan in 2 MHz steps. The receiver will first scan
the whole frequency band to find the transponders it can
lock on. After gathering all transponders, it scans the
transponders one by one to get all available programmes.
NetWork: Network search will be performed – when network
information is broadcasted, new transponders will be found
and stored.
Crytped: Press tu to select All Channels (scrambled and free) or
FTA Channels (free to air);
Service Type: Press tu to select ALL, DTV or Radio.
After configuring, press OK or BLUE again to start scanning with the
selected settings.
Your receiver will now perform an automatic channel search with the scan progress
shown on screen. During the channel search you can skip transponders by
pressing the MENU button, or quit the scan process with EXIT. When the process
To Next Page
Loading...
