This menu allows you to personalize the names of the 8 available favourite lists.
Use pq to select Rename Favourite List from the Edit Channel Menu and press to
proceed. The names of all groups are now displayed. Select a favourite group with pq and
press to edit its name. A text eld will now pop up at the right of the screen. Use tu
pq to select characters and enter them with . When you have nished editing, press
to save the changes. When all changes have been made, press twice to leave
this menu.
Use pq to select Installation and press or u to advance.
Select Auto Scan with pq and press to enter.
Use tu to toggle between Yes or No. When FTA Only is set to Yes, scrambled channels
won’t be stored in the channel list. Use pq to highlight Search. Now press to start
auto scan.
The receiver will store all found channels in the channel list.
Use pq to select Installation, press or u to advance.
Use pq to select Channel Scan and press to enter.
Use tu to toggle between available scan modes: By Channel and By Frequency.
If By Channel is selected, use the cursor buttons to select Scan Band and Channel No.
If By Frequency is selected, use the cursor buttons to select Frequency and Bandwidth.
Highlight Search and press to start scanning. Newly found channels will be added to the
channel list.
Use pq to select Installation, press or u to advance.
Use pq to select Antenna Power and press to enter.
Set to On if you use an active antenna.
Select Off for passive antennas.
When set to On, 5 V will be present on the ANT IN connector of the receiver.
Press to leave the Antenna Power menu.
If LCN (Logical Channel Numbering) is activated and an LCN signal is provided by the
operator, channels will be stored in an operator dened order. Set LCN to On to activate
operator dened channel numbering or Off to store channels in found order. This function
only applies when a new channel search is performed.
This menu allows you to manage the system settings of your receiver. It consists of the
following sub-menus: Language, TV System, Local Time Setting, Timer Setting, Parental
Lock, OSD Setting and Auto Standby.
To Next Page
Loading...
