After moving the receiver
to another room/area
you are no longer able to
receive digital reception
Antenna signals are too
weak
The signal strength/quality
might be less than before,
if using an indoor antenna.
Press the
button on
remote 3x to call up signal
bars and adjust antenna
for (maximum) reception
or rescan channels
When using an active
antenna, check antenna
power.
Try to use an outdoor
antenna.
The receiver switches off
automatically.
Auto Standby function
enabled.
Disable auto standby. See
section 7.3.7 for details.
Playback of video (or
Timeshift) is causing
picture freeze/macro
blocks or similar distortion,
especially on HD content.
Read/write speed of your
USB device could be too
low.
Make sure to use a USB
storage device with
sufcient speed and
space. Pen drives (‘USB
sticks’) may not support
sufcient speed.
Demodulator: COFDM; 16 QAM/64 QAM, QPSK
Transmission mode: 2 K - 8 K
Prole level: MPEG-2 MP@ML, AVC/H264HP@L4.1, MPEG4
ASP supported
Video resolutions: 480i / 480p / 576i / 576p / 720p / 1080i / 1080p / By
Native TV /By source
Decoding & Video out: PAL
Aspect ratio: 4:3 Letterbox, 4:3 Pan & Scan, 16:9, Auto
Audio support: AAC/DD+*/AC3/PCM
MPEG MusiCam Layer II
Sampling rate: 32, 44.1, 48 KHz
Audio mode: Stereo, Mono
*Dolby and the double-D symbol are registered trademarks of Dolby Laboratories
Front End: DVB-T, UHF & VHF Tuner
Input frequency range: 174 – 230 MHz (VHF) and 470 - 862 MHz (UHF)
Loop through frequency range: 47 - 862 MHz
Input signal level: -20 ~-84 dBm
To Next Page
Loading...
